![]() Two I fried, the other two I tested and they work.so I'm guessing what you got from small bear was good. I just got four of these myself from small bear a few weeks back. He only uses a marshall amp and a few other pedals. NEW TUBE DRIVER -20 OFF CV Relief Sale-279 The Original By BK BUTLER. EJ, DG & the other Pros get their Tube Drivers from me Brand New. I then tested that IC in a known working 9v bi-polar PS.and it was providing erroneous voltages.so.I burned out two of them this way before I figured that out. Scusatemi, ma i fili segnati nella foto, (quelli che escono dal trasformatore e vanno nella. How does Eric Johnson get the violin tone from one Every single youtube demo I have seen of the pedal sounds nothing like what he sounds like. Tube Works 910 Tube Driver (3 knobs) Tube Works 911 Tube Driver (4 knobs) B.K. TUBE DRIVER -20 OFF CV Relief Sale-279 The Original By BK BUTLER. ![]() I later found that if I increased the amperage from my bench PS, the tube heaters would glow.and I measured the amps during this process.ended up somewhere around 200 - 350mm for the heaters.too much for the 1054.but I wonder if the 7660 would work? At this point the 1054 IC in the PS got so hot it burned my fingers. The moment I put the tube in, the LED went away. what I found initially is that if my tube was not plugged in, my led on the PS lit but I got no sound. I don't have any 7660s but I plan on building a bipolar power supply based on what's on the schematic to rule the PS out.
0 Comments
Leave a Reply. |